Driver for Biostar 865G Micro 775
Biostar 865G Micro 775 Driver
BIOSTAR G Micro , REV, Socket LGA , Intel Motherboard+bonus: CPU Celeron GHz, RAM MB. Fully TESTED! % WORKING!Product. Manuals and user guide free PDF downloads for Biostar G MICRO This driver refers to systems containing the following Intel chipsets: Intel GM Chipset - Intel G Chipset - Intel GM Chipset.
|Supported systems:||ALL Windows 32x/64x|
|Price:||Free* [*Free Registration Required]|
Biostar 865G Micro 775 Driver
Biostar G MICRO Manual
Further the vendor reserves the right to revise this publication and to make c hanges to the c ontents here without obligation to notify any party beforehand. All the brand and produc t names are trademarks of their respec tive companies.
Table of Contents Chapter 1: Be fore you start installing the Biostar 865G Micro 775 rboard, please make sure you follow the instructions be low: Before you take the mothe rboard out from anti-static bag, ground yourse lf prope rly by touching any safe ly grounde d appliance, or use grounded wrist strap to remove the static charge. Avoid touching the compone nts on mothe rboard or the rear side of the board unless ne cessary.
Hold the board on the edgedo not try to be nd or flex the board. Do not leave any unfastene d small parts inside the case afte r installation.
Biostar 865G Micro 775 Loose parts will cause short circuits which may damage the equipment. Keep the compute r from dange rous a rea, such as hea t sourcehumid air and wate r. Data transfer rates up to 1. Remove Pin Cap before installation, and make good preservation for future use. Pin Cap Step 1: Pull the socket locking lever out from the socket and then raise the lever up to a degree angle.
Look for the triangular cut edge on socket, and the golden dot on CPU should point forwards this triangular cut edge. The CPU will fit only in the correct Biostar 865G Micro 775. Hold the CPU down firmly, and then lower the lever to locked position to complete the installation.
This completes the installation. The fan cable and connector may be different according to the fan manufacturer. Connect the fan cable to the connector while matching the black wire to pin 1.
Biostar G MICRO Support and Manuals
When c onnecti ng with wires onto connec tors, pleas e note that the red wire is the positi ve and s hould be c onnected to pin 2, and the blac k wire is Ground and s hould be c onnected to GND. Unlock a DIMM slot by pressing the retaining clips Biostar 865G Micro 775. Floppy Disk Conne ctor The motherboard prov ides a standard floppy disk connector that supports K, K, 1.
This connector supports the prov ided f loppy drive ribbon cables. The IDE connectors can connect a master and a slav e driv e, so you can connect up to four hard disk drives.
The f irst hard drive should always be connected to IDE1. This PCI slot is designated as 32 bits. Heade rs for USB 2. It will disable the output on back panel audio connectors.
Biostar 865G Micro 775 user manuals
Remov e AC power line. Wait f or f ive seconds.
Power on the AC. Reset y our desired password or clear the CMOS data. If the signal has been triggered, it will record to the CMOS and show the message on next boot-up.
Biostar G Micro Drivers Download - Update Biostar Software
You will see the following window after you insert the CD The setup guide will auto detect your motherboard and operating system. EXE under your optical drive. Driver Installation To install the driver, please click on the Driver icon. The setup guide will list the compatible driver for your motherboard and operating system.