ASRock H61M-GS Intel VGA Treiber

Seite 1 von Datenblatt zum Produkt Asrock H61M-GS S H61 MATX mit DC# Fragen zu dem Supports Intel® HD Graphics / H61M-GS. Solid Capacitor for CPU Power; Supports Intel® K-Series CPU; Supports Dual Channel DDR3 ; Supports Intel® HD Graphics /; Dual. Intel® Core™ CPUs (LGA socket) Unique On/Off Charge delivers the best Leading All Solid Capacitor Design Enhanced Intel HD Graphics /

Also remember to use a grounded wrist strap or touch a safety grounded object before you handle components. Hold components by the edges and do not touch the ICs. Whenever you uninstall any component, place it on a grounded antistatic pad or in the bag that comes with the component. Before you install or ASRock H61M-GS Intel VGA any component, ensure that the power is switched off or the power cord is detached from the power supply.

Do not force ASRock H61M-GS Intel VGA insert the CPU into the socket if above situation is found.

Suspicious Activity Detected

Otherwise, the CPU will be seriously damaged. Disengaging the lever by depressing down and out on the hook to clear retention tab.

Rotate the load lever to fully open position at approximately degrees. Rotate the load plate to fully open position at approximately degrees. It is recommended to use the cap tab to handle and avoid kicking off the PnP cap.

This cap must be placed if returning the motherboard ASRock H61M-GS Intel VGA after service. Insert the Pin CPU: Hold the CPU by the edge where is marked with black line. Locate Pin1 and the two orientation key notches. Carefully place the CPU into the socket by using a purely vertical motion. Verify that the CPU is within the socket and properly mated to the orient keys. Rotate the load plate onto the IHS.

While pressing down lightly on load plate, engage the load lever. Before you installed the heatsink, you need to spray thermal interface material between the CPU and the heatsink to improve heat dissipation.

Ensure that the CPU and the heatsink are securely fastened and in good contact with each other. For proper installation, please kindly refer to the instruction manuals of your CPU fan and heatsink.

Below is an example ASRock H61M-GS Intel VGA illustrate the installation of the heatsink for Pin CPU. Apply thermal interface material onto center of IHS on the socket surface. Apply Thermal Interface Material Step 2. Place the heatsink onto the socket. Align fasteners with the motherboard throughholes. Rotate the fastener clockwise, then press down on fastener caps with thumb to install and lock.

Repeat with remaining ASRock H61M-GS Intel VGA. Fan cables on side closest to MB header Fastener slots pointing straight out Press Down 4 Places If you press down the fasteners without rotating them clockwise, the heatsink cannot be secured on the motherboard.

Connect fan header with the CPU fan connector ASRock H61M-GS Intel VGA the motherboard. Secure excess cable with tie-wrap to ensure cable does not interfere with fan operation or contact other components. Please be noticed that this motherboard supports Combo Cooler Option C. Otherwise, it will operate at single channel mode.

ShieldSquare reCAPTCHA Page

If you install only one memory module or two non-identical memory modules, it is unable to activate the Dual Channel Memory Technology. It is not recommended to install them on this motherboard.

Unlock a DIMM slot by pressing the retaining clips outward.